Use of the Video Outdoor Panels
1. STAND-BY:
The call keys with the name of the residents are permanently backlighted during night. The Red LED
blinks permanently.
2. CALL:
Touch the key corresponding to the name of the family you are looking for. The call is acoustically signaled
with a ding-dong. Each touch of the key reinitiates the call.
4.
END OF TALK:
- After 1 min. from the call, if the resident does not answer.
- At 10 sec. after the door/gate is opened.
- Immediately, if the resident decides to end the talk without opening the door/gate.
3. TALK:
If the resident answers, talk is initiated. The maximum duration of the talk is 2 min.
5. ACCESS:
The door/gate will be open during the time set at the SCU (maximum 10 sec.). Access granting is
acoustically signaled through a confirmation beep sequence.
6. RFID TAG/CARD ACCESS:
If you program the RFID tags/cards in the outdoor panel, each resident of the building has
access using the secured RFID tag/card from BELLCOME. Approach the tag/card to the RFID area marked on the
outdoor panel. The access is signaled acoustically, through a confirmation beep sequence, and visually – the
symbol blinks white.
EN
9
Manual programming of the RFID TAGs/CARDs in the panel
At the moment of the delivery from the factory, the
TL
video outdoor panels do not have access tags/cards memorized.
In order to have access in the building after installation, it is mandatory to program the RFID tags/cards in the
outdoor panel.
During programming the installation has to be connected to the grid (110V/230Va.c.) and fully operational.
1.
Go to the place where the
SCU
central unit of the installation is mounted. Long press (3 sec.) the
PROG
button on
the
SCU
. The Red LED turns on.
2.
Take the RFID tags/cards to the outdoor panels. To program them, approach every tag/card for one second to the
RFID area of the outdoor panel. For each programmed tag/card, the panel issues two short beeps. Repeat this step
for programming all the RFID tags/cards.
3.
Go to the place where the
SCU
central unit of the installation is mounted. Short press the
PROG
button on the
SCU
.
The Red LED turns off. The installation returns to normal functioning, successfully ending the programming mode.
Orientable
video camera
RFID reader.
RFID tag/card access
Microphone
Fastening
Torx screw
IR LEDs
(
night lighting
)
Touch keys
for call,
with the name of the residents
Speaker
Fastening
Torx screw
1 Fam.
5 Fam.
2 Fam., 3 Fam.
Fam 2
Fam 1
Fam 3
Fam 4
Fam 5
Fam 1
29
4
mm
27
4
mm
115 mm
145 mm
5
EN
Deleting the RFID access TAGs/CARDs from the panel
5.2
EN
This procedure applies when you wish to
give up access with RFID tags/cards
. During the deletion of the
RFID
tags/cards
, the installation has to be connected to the grid (110V/230Va.c.) and fully operational.
1.
Go to the place where the
SCU
central unit of the installation is mounted. Long press (3 sec.) the
PROG
button on
the
SCU
. The Red LED turns on. The installation enters programming mode:
Not
e
:
The Red LED can be disabled through jumper JP1 (RED LED) on the board of the keyboard, when the
name labels are added.
5.1
EN