14
Energy Level
Energy level determines the intensity of the BellaLite™ light pulse delivered to your skin, from the lowest level (-) to the
highest level (+). Corresponding
INDICATOR LIGHTS
on the
CONTROL PANEL
represent the increases in energy. As energy
level increases, so does hair removal results as well as the risk of possible side effects and complications.
Always start your first BellaLite™ hair removal session at the lowest energy setting.
If you experience little or no discomfort during and after the hair removal session using the lowest energy level, raise
the energy level by one
INDICATOR LIGHT
at the next session, and so on for each subsequent session.
10. Remove the
APPLICATOR
TIP
from the treated area of skin.
11. Move the
APPLICATOR
TIP
to another area of skin.
Use the pressure marks the device just made on your skin to guide you for proper positioning of the next pulse, avoiding both gaps
and overlaps between pulses (See “Covering skin areas” frame).
12. Repeat the process starting again with Step 5.
If you see no light pulse and the
SKIN TONE WARNING INDICATOR LIGHT
blink for 3 seconds, your skin tone, measured by
the
SKIN COLOR SENSOR
, is too dark for safe application. Try using the device on a different body part or contact the
BellaLite™ support (See: “The Skin Color Sensor” frame)
Warning: Do not treat the same area of skin more than once per hair removal session! Treating the same area of skin
more than once per session increases the likelihood of adverse effects.
10.2. Treating with BellaLite™ for the first time
The skin should be shaved, clean, dry and free of any powders, antiperspirants or deodorants.
5. Press the
POWER ON/STANDBY SWITCH
. The
POWER ON INDICATOR LIGHT
will turn on and a fan sound (similar to the sound of a
hairdryer) will start.
6. Approximately 3.5 seconds after pressing the
POWER ON/STANDBY SWITCH
, the
READY INDICATOR LIGHT
will turn on and the device
will beep. The device sets itself to deliver the lowest energy level pulses. The device is then ready for you to trigger the first pulse.
7. If the energy level should be higher than the lowest, press the
ENERGY LEVEL SETTING BUTTONS
using the “-“ or “+” to respectively
decrease or increase the energy level, until the desired energy level is set.
ENERGY LEVEL INDICATOR LIGHTS
will coincide with the
energy level setting. (See “Energy Level” frame).
8. Apply the
APPLICATOR
firmly to the skin, making sure the skin is spread evenly and smoothly. Make sure the
APPLICATOR TIP
is in
full contact with the skin.
9. Press the
PULSE BUTTON
.
The device will first determine the color of your skin.
If the color of the skin is light enough for safe application, the device will flash a pulse of light onto your skin. You will see a bright
flash of light and simultaneously hear a subtle pop sound, which is a normal noise for the device. You may feel a mild sensation
of warmth and tingling.
BellaLite™ will immediately recharge for the next pulse. After 3.5 seconds the
READY INDICATOR LIGHT
will turn on again and the
device will beep.
