18 September 2003
PD001 Iss 2
- 17 -
Establishing Speech With a Calling Unit
To enable speech with the displayed room unit number, press the
*
button on the
keypad. The operator may then speak with the resident by pressing and holding the
'Privacy button' (grey button at top of the unit) and listen by releasing the button.
During speech one of the following display messages will be seen:
Speech with flat
12A; Volume low.
SPEECH LO 12A
Speech with flat 12A: Volume high.
SPEECH HI 12A
If there are additional alarm calls waiting to be dealt with the flat number and
re-assurance lamp (red LED) will flash.
Volume Adjustment During Speech
When a resident makes an alarm call he or she may be positioned close to the room
unit or a distance away. To allow for this, the M200+ system has a High and Low
volume level for received speech. The operator may change the volume level during
speech by alternately pressing the
*
button. The initial volume level may be preset
for each alarm type (refer to the Installation manual).
The Master unit microphone is always set at low volume because the operator will
always be close to the unit.
Summary of Contents for Master 200Plus
Page 4: ...18 September 2003 PD001 Iss 2 1 Diagram 1 The M200 Room Unit ...
Page 5: ...18 September 2003 PD001 Iss 2 2 Diagram 2 System Overview ...
Page 17: ...18 September 2003 PD001 Iss 2 14 Diagram 3 Gaining Access to Master or Monitor Mode ...
Page 24: ...18 September 2003 PD001 Iss 2 21 Diagram 4 Handling a Typical Alarm ...
