18 September 2003
PD001 Iss 2
- 8 -
Making an Emergency Call (Alarm)
An alarm call may be initiated at each M200+ room unit by one of the following
methods:-
a)
Operation of the
Call Button
(Orange button at the bottom of the unit).
b)
Operation of the
Pull-Cord
at the bottom of the M200+ unit (if fitted).
d)
Operation of the
Remote Switch
e.g. Illuminated ceiling pull switch.
e)
Activation of the
Smoke Detector
.
c)
Operation of the
'Pear-drop switch'
or other device which is plugged into the
jack-socket (or by inadvertent removal of the jack plug)
In each case the M200+ room unit will illuminate the
Re-Assurance Lamp (Red LED)
and
illuminated ceiling pull-switches
(if present).
The staff are alerted to alarms by:-
a)
Any room unit enabled as a Master/Monitor sounding an alarm tone, (provided
the unit is programmed to do so).
b)
Extension alarms, such as an audible alarm or flashing lamp (if present).
c)
A radio pager (if available).
A variety of alarm tone sounds may be programmed for each alarm type, e.g. the fire
alarm could be set to a continuous tone and the pull cord set to an intermittent warble.
Refer to the Installation Manual for full details of how to set the alarm tones.
Summary of Contents for Master 200Plus
Page 4: ...18 September 2003 PD001 Iss 2 1 Diagram 1 The M200 Room Unit ...
Page 5: ...18 September 2003 PD001 Iss 2 2 Diagram 2 System Overview ...
Page 17: ...18 September 2003 PD001 Iss 2 14 Diagram 3 Gaining Access to Master or Monitor Mode ...
Page 24: ...18 September 2003 PD001 Iss 2 21 Diagram 4 Handling a Typical Alarm ...
