(Figure 1)
3. Insert the Ni-Cd battery into the battery compartment.
4. Replace the battery compartment cover by sliding it up towards the handset.
NOTE: Use the type and size of Ni-Cd battery pack, 3.6V, 450mAh. It is
recommended that the Ni-Cd battery pack should be fully charged overnight prior
to initial use.
Belt Clip Installation
With the back of handset facing up, insert one side of the belt clip hook into the matching slots at the top
side of handset as shown in Figure2. Slide the other hook until it locks into place from the opposite side
of the handset.
Belt clip hook
(Figure 2)
POWER CONNECTION
CAUTION: You must use a Class II, 120 Volt AC/9 Volt DC adaptor that delivers at
least 500mA for base unit. The center tip must be positive and the plug must correctly fit
the base unit's DC 9V 500mA jack.
1. Plug the AC adaptor into a standard AC outlet.
2. Insert the small plug into the DC 9V 500mA jack on the rear of the base unit as shown in Figure 3.
Base Unit
AC Outlet
DC 9V Jack
AC Adaptor
Plug
030506A-1
8
Summary of Contents for 36077
Page 6: ......
Page 7: ...DESCRIPTIONS 030506A 1 6 ...