NOTE: The maximum incoming Message(ICM) recording time is 1 minutes. The minimum incoming
Message(lCM) recording time is 3 seconds.
VOICE MENU SYSTEM
A sophisticated Voice Menu System has been designed and pre-programmed into the 36077. This system
will verbally guide you through key operational procedures.
TIME/DAY STAMP
lCMs and Memo messages are automatically voice-stamped with the current time and day.
NOTE: After power failure, the time/day stamp will be lost. In this case, the time will be incorrect. Please
refer to the INITIAL SETUP section on how to set the system time and day.
SETTING ANSWER ON/OFF
The unit defaults to Answer ON automatically after power up.
A. TO TURN ANSWER MODE OFF
In standby mode, press the ANS. ON/OFF button on the base unit until you hear "Answering machine
is off".
NOTE: If the Answering Mode is OFF, the 36028 will answer after the 8
,h
ring. The 36028 will say
"Hello! I am unable to answer your call right now. Please call again thanks!"
B. TO TURN ANSWER MODE ON
In standby mode, press the ANS. ON/OFF button until you hear "Answering machine is on ".
NOTE: The 36028 will answer after ringing.
SETTING THE RINGS SWITCH (TS/4R/2R)
The number of rings before the answering system answers a call be selected by setting the RINGS switch
on the base unit to :
TS - Toll Saver
4 - Four rings
2 - Two rings
Toll Saver lets you avoid unnecessary toll charges when calling long distance to remotely retrieve your
messages.
The 36077 can be set to answer the first call on the 4
lh
ring, and all subsequent calls on the 2
nd
ring by
setting the RINGS switch on the Toll Saver (TS) position. If your 36077 fails to answer on the 2
nd
ring ,
then you know that you do not have any new incoming Message(s)(ICM). You can hang up before the
unit answers and save the cost of the call.
SETTING TIME/DAY
1. Press "TIME SET" button. You will hear current Time/Day setting the time and day.
2. Press and hold "TIME SET" button for about 3 seconds. You will hear "Sunday".
3. Press "SKIP •*-" or "REPEAT •**" button (on the base) until the correct day is announced.
4. Press "TIME SET" button to confirm and then set the hours. You will hear "12AM" as the "12AM" is
displayed in message counter.
5. Press "SKIP • • " button to advance or "REPEAT •**" button to reverse the hour show in the display.
6. Press "TIME SET" button to confirm and then set the minutes, you will hear "00" as the "00" is
displayed in message counter.
7. Press "SKIP »•" button to increment or "REPEAT ••*" button to decrement the minute in the
display.
8. Press "TIME SET" button to confirm. The new day and time will announced.
SETTING CODE
1. Press CODE button on the base. The base unit LED will show "1,5, 9".
2. Then you will hear the "one".
21
030506A-1
Summary of Contents for 36077
Page 6: ......
Page 7: ...DESCRIPTIONS 030506A 1 6 ...
