33
hElp
the Parent unit plays all sounds from the
Baby unit and i think it is too noisy
• you may have set the sensitivity level to Level 5 (maximum).
If so, the Baby unit will transmit any sound detected
to the Parent unit. To lower the sensitivity level.
• you may need to adjust the loud speaker volume on the Parent unit.
the Parent unit doesn’t play any sound when there is noise from
the Baby unit
• make sure the Parent unit has power. Check that the power adaptor
cable is correctly connected and the power is turned on at the wall
socket. Make sure that the battery in the Parent unit is fully charged.
• make sure the Parent unit is turned on and that
the loud speaker volume is not set to off.
• make sure the Parent unit is not monitoring in multi-CAM mode.
• check that the sensitivity level is not set too low
the link between the Baby and Parent unit is lost every now
and then and i’m experiencing sound or video interruptions
• move the Parent and Baby unit closer together (but not less
than 2 metres) as the Parent unit may be out of range.
• Reset the units by turning them off and unplugging the power
adaptor cables. Wait for 15 seconds and plug them back in.
Turn the units on and allow up to one minute for them to link.
the Parent unit doesn’t play any sound when
there is noise from the Baby unit
• make sure the Parent unit has power. Check that the power adaptor
cable is correctly connected and the power is turned on at the wall
socket. Make sure that the battery in the Parent unit is fully charged.
• make sure the Parent unit is turned on and that
the loud speaker volume is not set to off.
• make sure the Parent unit is not monitoring in multi-CAM mode.
• check that the sensitivity level is not set too low.
My Parent and Baby unit(s) are producing a high-pitched noise
• the Parent and Baby unit(s) may be too close together.
Make sure they are at least two metres apart.
• you may be too close to the Baby unit when you press and hold
the button. Make sure they are at least two metres apart.
• you may have set the sensitivity level too high. Try
adjusting to a lower level to avoid audio feedback.
