11
sEtting Up
If no connection can be
established, the Parent unit will
display
No link to CAM
for a
few seconds, then
Waiting for
linking…
The Link light will
continue to flash.
testing the units before use
It is important that you test the units before use
and at regular times thereafter, especially if
they have not been used for some time.
to test your units
1.Place the Parent and Baby units in the same room
but make sure they are at least 2 metres apart.
2.Press and hold the
button on the Baby unit
until the Power light on the button turns on.
3.Press and hold the button on the Parent unit until the
display shows
Waiting for linking
and the Link light flashes.
4.Press the
button on the Parent unit to
view the image from the Baby unit.
Pairing the units
The Parent and Baby unit supplied are already paired. You
can add or replace Baby units purchased separately to your
baby monitor system. You can pair a maximum of four Baby
units to your Parent unit. Each new Baby unit must be paired
to the Parent unit before use, see page 40 for instructions.
