28
Belkin® Secure Desktop Controller Unit (DCU) User Manual
-
8820-00778 Rev. A00
Section 4 - Operation
When the Secure KVM and the Belkin Secure DCU are properly installed and
configured, the system is ready for use. Default channel after power up is
channel #1 (all KVMs except for Windowing KVMs) as indicated by channel
select LED #1 illumination at the Secure KVM front panel and on the Belkin
Secure DCU display.
In the following example we will use a four-port Secure KVM to demonstrate
the Belkin Secure DCU operation.
Note:
Operation of F1DN002R model is similar to F1DN003R described here
but instead of the up/down and select push buttons use the 4 illuminated
push-buttons to control the cursor location and state.
Operation of F1DN001/2R is simply done by pressing the illuminated
buttons on the Belkin Secure DCU. The illuminated push buttons are actually
and extension of front panel push buttons of the KVM and behave exactly
the same.
Note
: once connecting the Belkin Secure DCU to the switch the front panel
push buttons of the KVM are disabled.
1. Channel selection on F1DN003R
You can select which computer you wish to control using the Belkin Secure
DCU through the following actions:
Default display after Belkin Secure DCU and KVM power up indicating
channel #1. KVM channel selected is #1. Arrow is pointing to the default
channel #1.
The user uses up/down push buttons to move the arrow to channel #2.
KVM is still switched to channel #1.
Table of Contents
SECTIONS
1 2 3
4
5 6 7
Operation