Thermal Cut-out Device
The plug-in heater is fitted with a thermal safety cut-out device, built in to prevent it
from overheating. Should the plug-in heater start to overheat, the thermal safety cut-out
system will automatically operate and the heat settings will switch off. If this happens:
STEP 1:
Switch off the plug-in heater by using the On/Off switch and at the mains
power supply.
STEP 2:
Allow plug in heater to cool before removing from plug socket.
STEP 3:
Allow it to cool for approx. 15 minutes.
STEP 4:
Clear any blockages present on the vent, being careful not to damage the plug-
in heater.
STEP 5:
Plug in and switch on the plug-in heater at the mains power supply.
Caution:
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
this plug-in heater must not be supplied through an external switching device such as a
timer or connected to a circuit that is regularly switched on and off by the utility.
Care and Maintenance
Always unplug the plug-in heater from the mains power supply and allow it to cool
sufficiently before performing any cleaning or maintenance. Wipe the exterior of the
plug-in heater with a soft, damp cloth and allow it to dry thoroughly. Do not use harsh or
abrasive cleaning solvents or scourers, as these may damage the finish of the plug-in
heater. Do not immerse the plug-in heater in water or any other liquid.
Getting Started
Remove the product from the box. Remove any packaging from the product. Place the
packaging inside the box and either store or dispose of safely.
In the Box
500W Handy Plug-in Heater
Instruction manual
Features
•
LED display with adjustable temperature control
•
500W power
•
Automatic cool-down function
•
Ceramic heating element
•
Cool-touch case
•
Overheat protection
•
Timer up to 12 hours
•
90° swivel plug
3
