Page 13
TLX640 Matrix Switch Product Manual
thinklogical
Rev. H, February 2020
Section 2: Set-Up & Installation
Contents
When you receive your Thinklogical
®
TLX640 KVM Matrix Switch, you should find the following
items in the quantities specified in your order:
•
TLX640 Chassis
(includes 4 Power Modules, Fan Tray, Up to 8 Switch Cards, Upper and Lower
Interconnect Cards and one or two Controller Cards)
•
Power Cord
– Qty. 1 per power supply – PWR-000056-R (International connections may differ)
•
Product Manual CD
•
Product Quick Start Guide
•
Chassis
Options (Spares)
:
•
Back-up Controller Card
•
Spare Switch Card
•
Spare Fan Tray
•
Spare Power Module
•
Data Input/Output Card, 20 Ports
The TLX640 KVM Matrix Switch ships configured to customer specifications. All physical connections to
the product use industry-standard connectors.
Unpacking the TLX640
The TLX640 is designed to be m
ounted in a standard EIA 19” rack.
All physical connections to the
product use industry-standard connectors. Non-supplied cables that may be needed are commercially
available. All connections are found on the rear of the unit.
1
Carefully remove the TLX640 KVM Matrix Switch from its shipping container. Inspect the unit to
make certain that no damage occurred during shipment.
2
All of the I/O cards are installed at the factory to meet your specific configuration. Ensure that the
I/O cards are properly seated in the unit and that all the SFP modules are sealed with a removable
dust plug. All I/O cards are held in place by thumb screw retainers.
Note: Ensure that all thumb screws are finger tight so that all the modules are properly
held in the chassis.
3
Verify that the four power supplies above the fan tray are secure in the chassis.
4
Verify that the fan tray is fully seated in the chassis and that the thumb screws are secure.
5
When the TLX640 has been inspected and found to be in suitable condition, the installation process
can begin.
