Page 19
TLX12 Matrix Switch Product Manual
thinklogical
Rev. E, Oct., 2019
How to Remove and Replace a Power Supply
The Power Module is universal input 100-240VAC, 50-60Hz. Use the proper power cords for your region
(PWR-000006-R, supplied with the unit). See the
Power Off
procedure, above.
1
Perform a
Poweroff
as shown, previous page. Ensure the power
cord is removed from the power supply module.
Warning!
Do not proceed to Step 2 until the Poweroff has
been completed.
2
Press the green latch in
(to the left) with your right hand while
grasping the handle with your left.
3
Pull the Power Module straight out
of the chassis by the handle.
4
Insert the new Power Module into the chassis
and slide it in until it reaches the backplane
connector. At this point, use just enough force to firmly engage the module with the mating connector
and lock the latch. Install the AC cord.
Warning!
If the module does not slide easily into the connector, do not force it! Damage
may occur. Remove the module and start over.
Summary of Contents for ThinkLogical TLX12
Page 1: ...Rev E Oct 2019 ...
