Belden Miranda Kaleido-X (4RU), Quick Start Manual

Page: 28 / 31

24
Setting Up Your Multiviewer
Verifying the Kaleido-RCP2
Verifying the Kaleido-RCP2
To verify that the Kaleido-RCP2 is functioning normally
• Log on to the Kaleido-RCP2 (see Using the Kaleido-RCP2 with Default Settings , on
page 10), and then test various operations using the Kaleido-RCP2 keyboard and the
mouse (e.g. load a predefined layout).
Verifying the Audio Bridge Terminal
To verify that the ABT is functioning normally
• Inspect the ACTIVITY and front panel LEDs on the unit to make sure there are no error
conditions:
The ACTIVITY indicator is located on the right-hand side of the rear panel. This LED
reports the status of the Ethernet connection as indicated in the table below.
Two LEDs are visible on the front panel, one for each power supply. When lit, they both
indicate the same status.
When the ABT is powered up, all three LEDs will be orange until the boot sequence is
terminated. This is a visual indicator that the LEDs are functioning properly.
RS-422 Connection Diagram
Each output card supports one RS-422 port over an RJ-45 connector. This port allows the
Kaleido-X to connect to external serial devices such as a router, production switcher, or
router controller.
The pinout for the RS-422 signals on the RJ-45 connectors, and the wiring diagrams for the
appropriate adapters, are shown here:
ACTIVITY Indicator on Rear Panel Power-Supply LEDs on Front Panel
Color Status Color Status
Off No link detected Green Normal
Green Normal (good link) Flashing green Normal, rebooting
Orange Activity Orange Warning
Red Hardware fault Flashing orange Warning, rebooting
Flashing red Upgrading firmware Red Hardware fault
Flashing red Upgrading firmware
Note:
The RS-422 ports each have an RJ-45 connector in order to preserve
space on a busy panel. The RS-422 interface specifies a DE-9 connector, so if
you are using this interface, you will require a DE-9-to-RJ-45 adapter.
Miranda supplies two adapter models, correctly wired for this application: a
straight adapter (part no. 1737-3000-102), and a crossover adapter (part no.
1792-3700-100).