Belden HIRSCHMANN SPIDER II, User Manual

Page: 6 / 36

6
Installation SPIDER II
Release 07 10/2013

Shielding ground

Beware of possible short circuits when connecting a cable section with
conductive shielding braiding.

Housing
Only technicians authorized by the manufacturer are permitted to open
the housing.
Note:
The device is grounded by means of a 3-pin terminal block.

Verify that the electrical installation meets locally or nationally
applicable safety regulations.

The device must be installed in the vertical position.

If installed in a living area or office environment, the device must be
operated exclusively in switch cabinets with fire protection
characteristics in accordance with EN 60950-1.
CAUTION
ELECTRIC SHOCK
Solely connect a supply voltage that corresponds to the type plate of your
device.
Never insert sharp objects (small screwdrivers, wires, etc.) into the inside of
the device.
Failure to follow these instructions can result in injury or equipment
damage.
CAUTION
OVERHEATING OF THE DEVICE
When installing the device, ensure that the ventilation slots are not covered.
Make sure there is at least 10 cm (3.94 in) of space.
Failure to follow these instructions can result in injury or equipment
damage.