Belden Hirschmann MAMMUTHUS MTM2700-2X, User Manual

Page: 39 / 72

Installing MAMMUTHUS SWITCH
Published on 01 01/2020
39
2 Installation
These devices are developed for use in commercial environments.
At the time of delivery, the equipment is ready for operation.
Follow the following steps to install and configure the equipment:
 Unpack the box for inspection

Install cover plate and power module (optional)

Install equipment and ground
 Operate equipment
 Install SFP transceiver (optional)
 Connect data cable
 Fill in the Device Label
2.1 Unpack the box for inspection
 Check whether the box contains all the items specified in "Delivery items"
on page 73.
 Check the parts one by one for damages incurred in shipment.
2.2
Install power module (optional)
2.2.1 Install power module
Hirschmann IT provides ready-to-run power modules. You can choose to
install the power module while the equipment is running.
Follow the steps below:

Remove the cover plate (if installed) from the power module slot of the
equipment.
 Plug the power module directly into the slot.
 Tighten 2 screws to secure the power unit to the equipment.
You can refer to the specified tightening torque in the “General technical
data” on page 49.