GUIDE TO INSTALLATION AND OPERATION
40
| AMX-1901
5.12.2 Meter Ballistics Config tab
Type
– select a type of meter from the pull-down
list
Upper Zone Limits
– select the crossover level
between the upper and middle zones of the meter
(the range of values shown in the pull-down list
depends on the type of meter selected)
Lower Zone Limits
– select the crossover level
between the middle and lower zones of the meter
(the range of values shown in the pull-down list depends on the type of meter selected)
Color samples
– the three samples show the current selected color for the upper, middle and lower zones of the
meter.
•
Click on the color sample of a zone to open a color selection panel to choose a different color for that zone
Overload Cursor
– The overload cursor appears on the meter as an arrowhead in the meter scale. The two pull-down
boxes set the position of the overload cursor on the left and right meters. If the audio level on a channel goes above
the cursor, the Overload Counter at the top of the meter is incremented.
This counter
shows a running count of the number of overloads detected.
The
Phasemeter
(located at the bottom of the RALM meter display) is a
small meter that represents the phase correlation factor between the two
channels of a pair.
180°
90°
0
Figure 5.32 RALM - meter ballistics configuration
Figure 5.33 RALM meter display
