18
Installation WLC
Release 04 07/2019
2
Configuration
2.1
Searching for and configuring the device
Configuring the BAT-Controller WLC involves the following steps:
Figure 3: Searching for and configuring the device
1 Via the local network (LAN)
2 Via the serial configuration interface
2.1.1
Configuration with LANconfig
Start LANconfig.
Note:
If LANconfig searches for the device without avail, check the network
connection and update the IP address of the configuration computer. You
can do that, for example, via the command line with ipconfig/renew, by
reactivating the network connection, or by restarting the computer. Then start
the search in LANconfig again.
Note:
Potentially, an activated "Internet connection firewall" or any other
active personal firewall bars the LANconfig from detecting devices in the
LAN. Deactivate the firewall while you carry out the configuration if
LANconfig searches for the unconfigured devices without avail.
The Basic Settings Wizard also starts by itself. It sets the following
parameters depending on the input of the user:
TCP/IP and DHCP settings
Restricting access to the configuration
DSL settings
1
2
Summary of Contents for 942 034-001
Page 28: ......
