MV-800 User Manual
Initial Checks and Actions
MV-800 Hardware Installation 3.2
Issue 2 Revision 1
Page 24
© 2019 Grass Valley, a Belden Brand
Insert the SFP video modules into the SFP cages on the MV-800 Rear Panel (1312).
The modules slide in until there is an audible click.
Start by filling the SFP cage for output pair 1 & 2, then 3 & 4 etc. see Figure 13.
Fill any remaining slots with SFP blanking plugs (SFP-BLANK).
SFP module removal, if required, is achieved by operating a small lever or lever-bar on the SFP
module before sliding the SFP video module out of its cage.
Figure 12 SFP orientation for fitting into 1312 Rear Panel SFP cages
Coax SFP
Fiber SFP
SFP Cages
SFP Blank plug
Note the orientation of the SFPs in this figure.
Specimen SFP module
Black plastic SFP protective dust cap, SFP Blanking plug
Figure 13 MV-800 outputs 1 to 12
Multiviewer MV-800 SFP Cages
1 & 2
5 & 6
3 & 4
7 & 8
11 & 12
9 & 10
