Beldeko DIEGO P200X2, Installation Instructions Manual

Page: 25 / 32

CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. To connect the liquid propane gas cylinder.
2. The cylinder valve should be in OFF position.
3. Make sure the burner valve is in OFF position.
4. Inspect the valve connections, port and regulator assembly. Remove debris and inspect
the hose for damage.
5. When connecting the regulator assembly to the valve, use your hand to tighten the nut
clockwise until it stops. Use of a wrench could damage the quick coupling nut and result in
a hazardous situation.
6. Open the cylinder valve fully by turning the valve counterclockwise.
7. Before lighting the oven, use a soap and water solution to check all connections for leaks.
8. If a leak is found, turn the cylinder valve OFF, and do not use the oven until local liquid
propane dealer can make repairs.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. Turn the oven burner valve OFF and make sure the oven is cool.
2. Turn the liquid propane cylinder valve OFF by turning clockwise until it stops.
3. Detach the regulator assembly from the cylinder valve by turning the quick coupling nut
counterclockwise.
4. Place dust cap for cylinder valve outlet whenever the cylinder is not in use.
LEAK TESTING GENERAL
Although the gas connections of the appliance are leak tested prior packing and shipment, a
complete test must be performed at the installation site.
Before each use, check all the gas connections for leak testing using the procedure listed
below. If the smell of gas is detected at any time, you should immediately stop using and
check the entire system for leaks.
BEFORE TESTING
Make sure all packing material has been removed from the appliance.
Make a solution of one part liquid detergent and one part water. You will need a spray
bottle, brush or rag to apply the solution to the fittings.