Beko WTAU12AW User Manual Download Page 10

Page: 10 / 11

Note: During the de spin process, if washing are piled at one side of the spin barrel,

it will cause unbalance of spin barrel resulting in striking. At this moment, the

computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can not
resolve the problem. Then the user has to manually and evenly place the clothing
inside the barrel to solve the problem.

No
washing

Abnormal
draining

Abnormal
spin

List of faults and inspection

Faults

Inspection Items

No water
flows in

If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power
switch is pressed.

If the door lid is closed.
If all clothing piled largely at one side of barrel or the clothing
is excessively placed.
If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
If the motor belt is loosened.

When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine without
permission.
If the washer can not work normally, or appear abnormity or alarms, please check and
correct as follows.

If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.

If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.
(The washer will not work if the water amount does not reach the
required water level)
If it is set to “Delay” washing mode. (It will only start to work
until the reservation time reached)

Identify usual trouble of washer

Cleaning and Maintenance of the washing machine

End of program

The washing machine will send off the
sound of “dou-dou” at the end of any
program operation to remind you to take
out the laundry or operate it again.
After the sound, the washing machine
returns to its power-off state with no
display and all lights off.
Please shut off the tap, pull out the plug
when not in use to avoid water leakage or
the fire accidents.

Maintenance

Use gentle clothing to wipe off the water and
dirt on the surface each time after using the

washing machine. Detergent, propellant and

other chemicals are not allowed
to use so as to avoid any
damage to the plastic
accessories.

Clean the water inlet

Clean Of the filter

After long time use, the

water

inlet mesh

bag may be blocked with smudginess, and
should be cleaned according to the
following steps:
1.Switch on the power, followed by shutting
off the tap.
2.Let the washer works for 5 seconds so
that water flows into the tub through the
water inlet hose.

then turn off the power.

3.Unload the water inlet hose and clean
the mesh bag, then restore the water inlet
assembly.

After using the washing machine for a
period, please clean it according to the
following steps:
1.Take off the

lint

filter.

2.Turn over the mesh bag and wash it
clean in the water.
3.Restore it and fix it.

Cleaning and Maintenance of the washing machine

Note:

If the drain filter is not cleaned at proper time (every 10 times of use),

Drain problem could

be caused.

1. Drain the water out of the
pump, under which use a
container to collect.