Beko WMI 61241, Installation & Operating Instructions And Washing Guidanse

Page: 7 / 48

EN
7
an earthed outlet protected by a fuse
of suitable capacity.
• The supply and draining hoses must
always be securely fastened and
remain in an undamaged state.
• Fit the draining hose to a washbasin or
waste system securely before starting
up your machine. There may be a risk
of being scalded due to high washing
temperatures!
• Never open the door or remove the
filter while there is still water in the
drum. Otherwise, there may be the
risk of flooding and possible injury due
to the hot water.
• Never force open the locked door!
The door will be ready to open just a
few minutes after the washing cycle
comes to an end.
• Unplug the machine when it is not in
use.
• Never wash down the appliance with a
water hose! There is the risk of electric
shock! Always disconnect from the
mains by unplugging before cleaning.
• Never touch the plug with wet hands.
Never unplug by pulling on the cable,
always pull out from the plug only. Do
not operate the machine if the power
cord or plug is damaged.
• Never attempt to repair the machine
yourself. Otherwise, you may be
putting yours and other’s lives in
danger.
• For malfunctions that cannot be
solved by information in the operating
manual:
Turn off the machine, unplug it, turn
off the water tap and contact an
Authorised service agent.
If there are children in your
house...
• Electrical appliances may be
dangerous for the children. Keep
children away from the machine when
it is operating. Do not let them tamper
with the machine.
• Close the door when you leave the
area where the machine is located.
• Store all detergents in a safe place out
of reach of the children.
• Use Child/Keylock to prevent children
altering the settings
Electrical connection
Make sure that you have an earthed power
outlet socket rated at 13 amps (minimum).
Attention!
If you place your machine under a
worktop, the socket must be reachable
after installation, or a separate switch
(which can disconnect the two poles) must
be used in the installation.
Connect the power cord to the appropriate
electrical socket with an equivalent current
rating indicated on the rating plate at the
front of the machine behind the kick plate.
After removing the plug from its transit
position, please insert the plug seal
to prevent water spillage entering the
machine.
Electrical requirements
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
Should the mains lead of the appliance
become damaged or need replacing at
any time, it must be replaced by a special
purpose made mains lead which can only
be obtained from a Authorised Service
Agent.
B This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut
off and an appropriate plug fitted.
Destroy the old plug, which is cut off as a
plug with a bare cord could cause a shock
hazard if inserted into a socket elsewhere
in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse
need to be replaced an ASTA approved
BS1362 fuse of the same rating must be