Beko WMD 78144, Installation & Operating Instructions And Washing Guidanse

Page: 29 / 40

EN
29
Cause Explanation / Suggestion
Programme cannot be started or selected.
Machine may have switched to
self protection mode due to an
infrastructure problem (such as line
voltage, water pressure, etc.).
Bring your machine to factory settings by turning
the programme selection knob. (see, Ending the
programme through Cancelling)
Water in the machine.
There may be some water in your
machine when you receive it. This is
from the quality control process and is
normal.
It is not harmful to your machine.
There is water coming from the bottom of the machine.
There might be problems with hoses or
the pump filter.
- Make sure that the seals of the water inlet hoses
are securely fitted.
- Tightly attach the drain hose to the tap.
- Make sure that the pump filter is completely
closed.
Machine does not fill with water
- Tap may be turned off.
- Water inlet hose might be bent.
- Water inlet filter might be clogged.
- The loading door may be ajar.
- Open the inlet water taps fully.
- Flatten the water intake hose.
- Clean the water intake filter.
- Close the loading door.
Machine does not discharge water.
- Water outlet hose might be clogged
or twisted.
- Pump filter may be clogged.
- Clean or flatten the hose.
- Clean the pump filter.
Machine vibrates or shakes.
- Machine feet might not be adjusted.
- Transportation safety bolts might have
not been removed.
- There may be a small amount of
laundry in the machine.
- The machine may be overloaded
or the clothes may be distributed
unevenly.
- There machine might be touching a
solid surface.
- Adjust the machine feet.
- Remove the transportation safety bolts.
- Add more laundry to the machine.
- Reduce the amount of laundry in the machine or
balance the load by hand.
- Ensure that nothing touches the machine.
Machine stops shortly after the programme starts.
Machine can stop temporarily due to
low voltage.
It will resume operating when the voltage is back to
the normal level.
The water being taken in is directly discharged.
Improper position of the drain hose.
Connect the water draining hose as described in
the operation manual.
No water can be seen in the machine during washing.
This is not a problem. The water level
is not visible from the outside of the
machine.
8 Solution suggestions for problems