EN
25
under streaming water.
• Replace the gaskets and filters
carefully and tighten the hose nuts by
hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
during discharging of the washing water.
Thus, a good water discharge is achieved
and the pump life is extended.
• If your machine fails to drain the water,
the pump filter may be clogged. You
may have to clean it every 2 years or
whenever it is blocked plugged. Water
must be drained off to clean the pump
filter.
In addition, water may have to be drained
off completely in the following cases:
• before transporting the machine (e.g.
when moving house)
• when there is the danger of frost
In order to clean the dirty filter and
discharge the water;
1- Disconnect or unplug the machine from
the power supply.
A
There may be water at 90°C in the
machine. Therefore, the filter must be
cleaned only after the inside water
is cooled down to avoid hazard of
scalding.
2- Open the filter cap. The filter cap
may be composed of one or two pieces
according to the model of your machine.
If it is composed of two pieces, press the
tab on the filter cap downwards and pull
the piece out towards yourself.
If it is composed of one piece, hold it from
both sides and open it by pulling out.
C
You can remove the filter cover
by slightly pushing the kick plate
downwards with a screwdriver,
through the gap above the filter cover.
3- An emergency drain hose is supplied
with some of our models. Others are not
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following as
shown in the figure below:
• Pull out the pump outlet hose from its
housing.
