EN
24
Detergent drawer
Remove any powder residue buildup in
the drawer. To do this;
1. Press the dotted point on the siphon
in the softener compartment and pull
towards you until the compartment is
removed from the machine.
C
If more than a normal amount of water
and softener mixture starts to gather
in the softener compartment, the
siphon must be cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water
in a washbasin. Wear protective
gloves or use an appropriate brush
to avoid touching the residues in the
drawer when cleaning.
3. Replace the drawer into its housing
after cleaning. Check if the siphon is
in its original location.
The door and the drum
After each wash:
• Check if there are any foreign
substances in the drum.
• Open the hole in the bellow with the
aid of a toothpick if it is clogged.
C
Foreign metal substances in your
machine can cause rust stains. In
such cases:
7
Cleaning and care
Clean the drum with a stainless steel
cleaning agent. Never use steel wool
or wire wool.
Outer cabinet and control panel
When necessary:
• Wipe the exterior panels of your
machine with soapy water or mild
detergent. Dry it with a soft cloth.
• Use only a soft and damp cloth to
clean the control panel.
C
Never use a sponge or scrubbing
material. These will damage the
painted and plastic parts.
Inlet water filters
There is a filter at the end of each water
intake valve at the back side of the
machine and also at the end of each water
intake hose where they are connected to
the tap. These filters prevent the foreign
substances and dirt in the water to enter
into the machine. Filters should be cleaned
as they get dirty.
• Close the taps.
• Remove the nuts of the water intake
hoses to clean the surfaces of the
filters on the water intake valves with
an appropriate brush.
• If the filters are very dirty, you can pull
them out by means of pliers and clean
them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly
