Beko WIC74545F2, User Manual

Page: 16 / 56

16 / EN
Washing Machine / User’s Manual
Adjusting the feet with water level
• You must remove the Detergent Drawer to set the Water Level.
• For the system to operate properly, the bubble inside the Water Level must be in the
middle .
• If the bubble inside the Water Level is on the left , the pre-set right foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is on the right , the pre-set left foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is at the back , the pre-set front feet of the
Washing Machine must be turned to the left (clockwise).
• If the bubble inside the Water Level is at the front , the pre-set front feet of the
Washing Machine must be turned to the right (anti-clockwise).
4.4.7 Electrical connection
Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not
be liable for any damages that will arise when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
• The voltage specified in the “Technical specifications” section must be equal to your
mains voltage.
• Do not make connections via extension cables or multi-plugs.
B
WARNING:
Damaged power cables must be replaced by the Authorised Service Agents.