62 / EN
Washer-Dryer
Maintenance and cleaning
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake
valves. Clean residues on them with an appropriate brush. If the filters are too dirty,
remove them from their places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water.
4. Replace the gaskets and filters carefully in their places and tighten the hose nuts
by hand.
6.5 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and
fabric fibres clogging the pump impeller during discharge of washing water. Thus,
the water will be drained without any problem and the service life of the pump will
extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months. Water must be drained off first to clean
the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house)
and in case of freezing of the water, water may have to be drained completely.
A
CAUTION
• Foreign substances left in the pump filter may damage
your product or may cause noise problem.
• If the product is not being used, shut the tap, remove
mains hose and drain the water inside the machine in
places where there is the risk of the product freezing .
• After each use, turn off the water tap to which the
mains hose is connected.
