Beko NEOFROST, User Manual

Page: 7 / 24

6 /23 EN Refrigerator / User Guide
3 Installation
3 1 Right place for installation
Contact the Authorized Service for
the product's installation. To ready
the product for installation, see the
information in the user guide and make
sure the electric and water utilities are
as required. If not, call an electrician
and plumber to arrange the utilities as
necessary.
B
WARNING: The manufacturer assumes
no responsibility for any damage
caused by the work carried out by
unauthorized persons.
B
WARNING: The product’s power
cable must be unplugged during
installation. Failure to do so may
result in death or serious injuries!
A
WARNING: If the door span is too
narrow for the product to pass,
remove the door and turn the
product sideways; if this does not
work, contact the authorized service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to
direct sunlight or keep in damp
environments.
• The product requires adequate air
circulation to function efficiently.
• If the product will be placed in an
alcove, remember to leave at least 5
cm distance between the product and
the ceiling and the walls.
• Do not install the product in
environments with temperatures
below -5°C.
3 2 Attaching the plastic wedges
Use the plastic wedges in the provided
with the product to provide sufficient
space for air circulation between the
product and the wall.
1.
To attach the wedges, remove the
screws on the product and use the screws
provided with the wedges.
2.
Attach 2 plastic wedges on the
ventilation cover as shown in the figure.
3 3 Adjusting the stands
If the product is not in balanced
position, adjust the front adjustable
stands by rotating right or left.
3 4 Power connection
A
WARNING: Do not use extension or
multi sockets in power connection.
B
WARNING: Damaged power cable
must be replaced by Authorized
Service.
C
When placing two coolers in
adjacent position, leave at least 4
cm distance between the two units.
•
Our firm will not assume
responsibility for any damages
due to usage without earthing and
power connection in compliance
with national regulations.
•
The power cable plug must be easily
accessible after installation.
•
Connect the refrigerator to an
earthed socket with 220-240V/50 Hz
voltage. The plug must comprise a
10-16A fuse.
•
Do not use multi-group plug with
or without extension cable between
the wall socket and the refrigerator.