10/EN
3
Installation
Refer to the nearest Authorised Service Agent for
installation of the product. Make sure that the
electric and gas installations are in place before
calling the Authorised Service Agent to have the
product ready for operation. If not, call a qualified
electrician and fitter to have the required
arrangements made. The manufacturer shall not
be held responsible for damages arising from
procedures carried out by unauthorized persons
which may also void the warranty.
Preparation of location and electrical and
gas installation for the product is under
customer’s responsibility.
DANGER:
The product must be installed in
accordance with all local gas and/or
electrical regulations.
DANGER:
Prior to installation, visually check if the
product has any defects on it. If so, do
not have it installed.
Damaged products cause risks for your
safety.
Before installation
•
The appliance corresponds to device class 1,
i.e. it may be placed with the rear and
one
side to kitchen walls, kitchen furniture or
equipment of any size. The kitchen furniture
or equipment on the
other
side may only be
of the same size or smaller.
•
Any kitchen furniture next to the appliance
must be heat-resistant (100 °C min.).
Room ventilation
All rooms require an openable window, or
equvalent, and some rooms will require a
permanent vent as well.
The air for combustion is taken from the room air
and the exhaust gases are emitted directly into
the room.
Good room ventilation is essential for safe
operation of your appliance. If there is no window
or door available for room ventilation, an extra
ventilation must be installed.
The appliance may be located in a kitchen,
kitchen/diner or a bed-sitting room, but not in a
room containing a bath or shower. The appliance
must not be installed in a bed-sitting room of
less than 20m
3
.
Do not install this appliance in a room below
ground level unless it is open to ground level on
at least one side.
Room size
Ventilation opening
smaller than 5 m
3
min. 100 cm
2
5 m
3
to 10 m
3
min. 50 cm
2
greater than 10 m
3
'den not required
In the cellar or
basement
min. 65 cm
2
Installation and connection
Product can only be installed and connected in
accordance with the statutory installation rules.
Do not install the product next to
refrigerators or freezers. The heat emitted
by the product will increase the energy
consumption of cooling appliances.
Do not use the door and/or handle to carry
or move the product. The door, handle or
hinges get damaged.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated
in the "Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or
without a transformer. Our company shall not be
liable for any damages that will arise due to
using the product without a grounding installation
in accordance with the local regulations.
