Installation and operation manual
EN
6
DRYPOINT
®
M eco control
1.4. Transport and storage
Despite our best efforts regarding packaging etc., the device might be damaged during transport. Please therefore remove
all packaging material immediately after receipt and inspect the product for any possible transport damage. Any damages
must be immediately notified to the transport company and BEKO TECHNOLOGIES GMBH or one of their agents.
CAUTION
Damage caused during transport or storage
Incorrect transport or storage, or the use of unsuitable lifting equipment, might cause damage to
the device.
•
The device must only be transported and stored by authorised and suitably trained technical
personnel.
•
If you detect any damage, do not start the device.
•
Always comply with the permissible storage and transport temperatures (refer to technical
data).
•
Never expose the device to continuous, direct sunlight or heat radiation.
The device must be stored in the original
packaging. Seal the packaging and store it in a
dry and frost-free room. Ensure that the ambient
conditions do not fall below or exceed the limits
specified on the type plate.
Always take suitable measures to protect the
device against the elements even in a packaged
condition.
While in storage, secure the device so that it
cannot topple over or fall, and protect it against
vibration.
NOTE
Recycling packaging material
• The packaging material is recyclable. Dispose of the packaging material according to the
applicable statutory regulations.
