EN
15
Filling in the water reservoir
Open the lid of the water reservoir located inside
of the door as illustrated and fill in with water at
room temperature or colder using a carafe. Close
the lid.
You can remove the water reservoir to fill it
outside the refrigerator and also to clean it.
You can easily carry the water reservoir by its
handle.
Warning!
Water spring is only intended for use with
drinking water. Do not put hot water, juice,
milk and gaseous or alcoholic beverages into
the water reservoir.
If there is a power failure (water can not be
obtained from the water dispenser if your
refrigerator is not energized.)
Dripping Crenel
Water drops that drip while using your water
spring accumulates in the dripping crenel at
the lower side. Remove the dripping crenel to
remove the accumulated water. You can remove
the water with a sponge or a soft cloth.
Cleaning the water reservoir
Take out the water reservoir after removing
the cover mechanism on the left hand side as
illustrated in the figure. Clean the water reservoir
with warm water, replace it and close the cover
on the left hand side.
Make sure that the cover on the right hand side
fits into the water inlet hole after installing the
water reservoir. Otherwise, water leakage may
occur.
(Washing in the dishwasher may cause the water
reservoir to get scratched.)
Summary of Contents for DNE 65500 DE
Page 1: ...No Frost 霜冰箱 DNE 65500 DE ...
Page 22: ...DNE 65500 DE No Frost ...
Page 46: ...4849790002 ...
Page 47: ...4849790002 ...
