Beko DIN16210, User Manual

Page: 19 / 43

Dishwasher / User’s Manual
17 / 41
EN
Preparation
as 3in1, 5in1, Allin1 etc. They function
only up to a specific degree of water
hardness. Above this limit regeneration
salt and rinse aid must be added. Refer to
the instructions on the packaging of the
combined detergent whether it is suitable
for the hardness level of the water supply.
C
While using combined tablet
detergents contact with
the detergent producers if
the dishes are wet and/or if
you notice limescale spots
particularly on glasses after the
washing programme is over.
C
The best washing performance
in dishwashers is obtained
by using detergent, rinse
aid and water softening salt
individually.
When you switch to powder, liquid/gel or
tablet detergent from a combined tablet
detergent:
1. Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the highest
level and perform an empty run.
3. After the empty washing cycle, review
the user manual and readjust the
water hardness level so as to suit the
water supply.
4. Make the appropriate rinse aid
settings.
C
Depending on the model,
salt indicator and/or rinse aid
indicator must be enabled again
if they were disabled before.
Rinse aid
C
The rinse aid used in
dishwashers is a special
combination used to increase
drying efficiency and prevent
water or limescale stains on the
washed items. For this reason,
care must be paid to have rinse
aid in the rinse aid reservoir
and to use rinse aids produced
specially for dishwashers only.
1. Open the lid of the rinse aid reservoir
by pressing its latch (B).
2. Fill the reservoir until “MAX” level.
3. Turn the rinse aid amount adjuster
manually to a position between 1 and
6 (4). If there are stains on tableware
items after washing, level must be
increased and if there is a blue trace
after wiping them by hand, it must be