Beko DC 1570, Manual

Page: 5 / 76

5 - EN
2
Installation
Refer to the nearest Authorised Service
Agent for installation of your product.
C
Preparation of location and electrical
installation for the product is under
customer’s responsibility.
B
Installation and electrical connections
must be carried out by a qualified
personnel.
A
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products will cause risks for your
safety.
Appropriate installation locati-
on
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the product with materials
such as long pile rugs and wooden
bands.
• Do not place your product on a long
pile rug or on similar surfaces.
• Do not install the product behind a
door with a lock, sliding door or a
hinged door which can strike the
product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure
that the rear wall of it does not touch
anywhere (tap, socket, etc.) and also
pay attention to install the product at a
place where it will stay permanently.
B
Do not place the product on top of the
power cable.
• Keep at least 1.5 cm distance to walls
of other furniture.
Under counter installation
• A special part (Part no: 295 970 0100)
replacing the top trim must be provided
and installed by the Authorised Service
Agent in order to use the machine
under a counter or in a cupboard. It
should never be operated without the
top trim.
• Leave at least 3 cm of space between
the side and rear walls of the product
and the walls of the counter/cupboard
when installing your product under a
counter or in a cupboard.
Mounting over a washing mac-
hine
• A fitting device should be used
between the two machines when
installing above a washing machine.
The bracket (Part no. 296 280 0100
white/296 280 0200 grey) must be
installed by the Authorised Service
Agent.
• Place the product on a firm floor. If
it will be placed on top of a washing
machine, the approximate weight of
both machines may reach 180 kg when
they are full. Therefore, the floor must
be capable of carrying the load on it!
Ventilation hose and connecti-
on (for products equipped with
an outlet vent)
Ventilation hose allows exhaust air from
inside the machine
Vented dryer has 1 air outlet.
Stainless sheet metal or aluminum pipes
can be used instead of a hose. The pipe
diameter should be minimum 10 cm.
Maximum hose and pipe lengths are
given in the table below.
Hose Pipe
Maximum length
4 m 5 m
1 elbow 45°
-1.0 m -0.3 m
1 elbow 90°
-1.8 m -0.6 m
1 elbow 90° short
-2.7 m
1 wall passage
-2.0 m -2.0 m
C
Each elbow and other passages should
be subtracted from the maximum
length stated above.