Beko CHS 30100 SS, User Manual

Page: 15 / 60

Range Hood / User Manual
15 / 56 EN
4 Installing your appliance
Step 11
Cut holes at marked locations for duct and
electrical wiring. For the vertical duct, cut out 3/4”
extra toward the front of the cabinet so you can
move the duct freely when installing the hood.
It may also ease installation by cutting the hole 10
1/ 2” instead of 10”.
Step 12
Drive a mounting screw (from the hardware
packet) partway into each center of the narrow
neck of the keyhole slots marked on the cabinet
bottom.
Step 13
Fix the wiring conduit to the hood.
Step 14
Slide the hood back against the wall. Tighten the
mounting screws. Be sure the screw heads are in
the narrow neck of the keyhole slot.
Connect Ductwork to hood.
Step 15.
Electrical connection
A
WARNING: Electrical Shock
Hazard
Turn off power circuit at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit
required.
Electrical grounding instructions
This appliance is fitted with an electrical junction
box with 3 wires, one of which (green/yellow)
serves to ground the appliance.
To protect you against electric shock, the green
and yellow wire must be connected to the
grounding wire in your home electrical system,
and it must under no circumstances be cut or
removed.
Failure to do so can result in death or electrical
shock.
Remove the knockout and the Junction box cover
and install the conduit connector (cULus listed) in
junction box.
Run 3 wires; black, white and green ,according to
the National Electrical Code and local codes and
ordinances, in 1/2” conduit from service panel to
junction box.
Connect black wire from service panel to black or
red in junction box, white to white and green to
green-yellow.
Close and secure junction box cover.
Step 16
Final installation steps
Replace filters.
Check operation of the hood.
If range hood does not operate:
•
Check that the circuit breaker is not tripped or
the house fuse blown.
•
Disconnect power supply. Check that wiring is
correct.
To get the most efficient use from your new range
hood, read the “Use and Care Information” section.
Keep your Installation Instructions and Use and
Care Guide close to range hood for easy reference.