TRANSPORTATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
1. The appliance should be transported only in an upright position. The packing as supplied
must be intact during transportation.
2. If during the course of transport the appliance has to be transported horizontally, it must
only be laid on its left hand side when standing in the front of the appliance. After bringing it
to upright position,it must not be operated for at least 4 hours to allow the system to settle.
3. Failure to comply with the above instructions could result in damage to the appliance, for
which the manufacturer will not be held liable.
4. The appliance must be protected against rain, moisture and other atmospheric influences.
5. When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the door or handle.
6. Empty any water in the drain tray before moving. See section „Defrosting” and „Care &
cleaning” for further information.
7. Make sure that the defrost water pipe at the back of the product is fixed to the plastic
evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.
Care must be taken while cleaning/carrying the appliance not to touch the bottom of the
condenser metal wires at the back of the appliance, as this could cause injury to fingers and
hands.
Do not attempt to sit or stand on top of your appliance as it is not designed for such use.
You could injure yourself or damage the appliance.
Make sure that the mains cable is not caught under the appliance during and after moving,
as this could damage the cable.
Do not allow children to play with the appliance or tamper with the controls.
plc declines to accept any liability should the instructions not be followed.
The space in the room where the appliance is installed must not be smaller than 10 cubic
metres.
Do not place the appliance near cookers, radiators or in direct sunlight as this
will cause your appliance to work harder. If installed next to a source of heat or freezer,
maintain the following minimum side clearances:
Important!
!
!
!
!
BEKO
1.
2.
This appliance has been designed to operate in ambient temperatures up to 32 degrees C
(90 degrees F) and is equipped with Freezer Guard which ensures that at the advised
setting [4 - four on the knob] the frozen food in the freezer will not defrost even if the ambient
temperature falls as low as -15 °C. When first installed the product MUST NOT be placed in
low ambient temperatures because the freezer will not reduce to it’s standard operating
temperature. Once it has reached its steady operating state it can be re-located. So you
may then install your appliance in a garage or an unheated room without having to worry
about frozen food in the freezer being spoilt. When the ambient temperature returns to
normal, you may change the knob setting to suit your needs. If the ambient temperature is
below 0°C, the food in the fridge compartment will freeze. So, we recommend you don’t use
the fridge compartment in such low ambient conditions. You can continue using the freezer
compartment as usual.
From Cookers
2" (50 mm)
From Radiators
12" (300 mm)
From Refrigerators or Larder Fridge
1" (25 mm)
4
