11
TEMPERATURE CONTROL AND ADJUSTMENT
Operating temperatures are controlled by the setting knob (see diagram) located on the
ceiling of fridge compartment. Settings may be made from min, 1 ... 6, max, max being the
coldest position.
When the appliance is switched on for the first time, the setting knob should be adjusted so
that after 24 hours, the average fridge temperature is no higher than +5°C (+41°F). We
recommend you set the knob
between the min and max setting and monitor to
obtain the desired temperature i. e. towards max you will obtain a colder fridge temperature
and vice versa. Some sections of the fridge may be cooler or warmer (such as the salad
crisper and the top part of the cabinet) which is quite normal.
The normal storage temperature of the freezer should be -18°C (0°F). Lower temperatures
may be obtained by adjusting setting knob towards max position.
We recommend that you check the temperature with an accurate thermometer to ensure
that the storage compartments are kept to the desired temperature.
Remember you must take your reading very quickly since the thermometer temperature will
rise very rapidly after you remove it from the freezer.
Please remember each time the door is opened cold air escapes and the internal
temperature rises. Therefore never leave the door open and ensure it is closed immediately
after food is put in or removed.
In case of a temporary ice build up in the fridge compartment, reduce the setting to min,
monitoring at the same time that the fridge temperature is m5 degrees C [41
degrees F]. Once the ice build up disappears and the appliance starts auto defrosting again
as normal, then you may increase the setting, if required.
Before you start using the appliance check that:
1. The feet have been adjusted for perfect levelling.
2. The interior is dry and air can circulate freely at the rear.
3. The interior is clean as recommended under "Cleaning and care.
”
4. The plug has been inserted into the wall socket and the electricity is switched on. When
the door is open the interior light will come on.
5. You will hear a noise as the compressor starts up. The liquid and gases sealed within the
refrigeration system may also make some (noise), whether the compressor is running or
not. This is quite normal.
6. Slight undulation of the top of the cabinet is quite normal due to the manufacturing
process used; it is not a defect.
7. We recommend setting the thermostat knob midway and monitor the temperature to
ensure the appliance maintains desired storage temperatures (See section Temperature
Control and Adjustment).
8. Do not load the appliance immediately it is switched on. Wait until the correct storage
temperature has been reached. We recommend checking the temperature with an accurate
thermometer (see; Temperature Control and Adjustment).
on 5 position
BEFORE OPERATING
Final Check
And note that:
x
7
E
P
R
O
