Beko BBIE22300XFP, User Manual

Page: 32 / 48

EN / 32
• Discolorations and stains on the glass sur-
face are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm water
and a soft cloth or sponge and dry them
with a dry cloth.
• Do not use hard metal scrapers and ab-
rasive cleaners. They may damage the
surfaces.
• Ensure that the joints of the components
of the product are not left damp and with
detergent. Otherwise, corrosion may occur
on these joints.
7.2 Cleaning Accessories
Do not put the product accessories in a
dishwasher unless otherwise stated in the
user’s manual.
7.3 Cleaning the Control Panel
• When cleaning the panels with knob-con-
trol, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Do not remove the knobs and gaskets un-
derneath to clean the panel. The control
panel and knobs may be damaged.
• While cleaning the inox panels with knob
control, do not use inox cleaning agents
around the knob. The indicators around
the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth. If
your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
7.4 Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" [
}
30] section
according to the surface types in your oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls. It
varies by model. If there is a catalytic wall,
refer to the “Catalytic surfaces” [
}
31] section
for information.
If your product is a wire shelf model, remove
the wire shelves before cleaning the side
walls. Then complete the cleaning as de-
scribed in the "General Cleaning Informa-
tion" [
} 30] section according to the side wall
surface type.
To remove the side wire shelves:
a. Remove the front of the wire shelf by
pulling it on the side wall in the opposite
direction.
b. Pull the wire shelf towards you to remove
it completely.
c. To reattach the shelves, the procedures
applied when removing them must be re-
peated from the end to the beginning, re-
spectively.
7.5 High temperature self-cleaning
The oven is equipped with a pyrolysis fea-
ture. The oven heats up to a temperature of
approximately 420-480 °C and burns until
the existing dirt turns to ash. A strong smoke
may be generated. Provide good ventilation.
High-temperature cleaning should be per-
formed after approximately every 10 uses of
the oven.