EN / 54
Washing Machine / User’s Manual
13.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the
product and also at the end of each water intake hose where they are
connected to the tap. These filters prevent foreign substances and dirt in
the water to enter the product. Filters should be cleaned if they are dirty.
a) Close the taps.
b) Remove the nuts of the water intake
hoses to access the filters on the water
intake valves. Clean them with an
appropriate brush. If the filters are too
dirty, remove them from their places with
a pliers and clean in this way.
c) Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
running water.
d) Replace the gaskets and filters carefully in
their places and tighten the hose nuts by
hand.
13.5 Cleaning the pump filter
CAUTION!
• Foreign substances left in the pump filter may damage
your product or may cause noise problem.
• In regions where freezing is possible, the tap must be
closed, system hose must be removed and the water inside
the product must be drained when the product is not in use.
NOTE
• After each use, turn off the tap to which the mains hose is
connected.
The filter system in your product prevents solid items such as buttons, coins
and fabric fibers clogging the pump impeller during draining of washing
water. Thus, the water will be drained without any problem and the service
life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter
must be cleaned whenever it is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
