Operation
Operating manual
KINET
V1.4 E
Page 18 of 40
8.3 During use
Installing the patient/resident in the tub
Caution
If the tub has to be positioned in seated position to install the
patient/resident in the tub, the tub must not contain any water!
Otherwise, the water would flow out of the tub!
To install the patient/resident in the tub, simple bring the bath tub to seated position by
pressing the button
on the handset.
When the bath tub is in seated position, help the patient/resident into the bath tub or
let him/her step into the tub.
If you use a patient lift system to install the patient in the bath tub, you can leave the
tub in reclined position as well.
Bring the bath tub to reclined position by pressing the button
on the handset.
Filling the bath tub
Image 1:
Close the drain of the
bath tub by turning the
eccentric fitting counter-
clockwise.
Image 2:
Open the valve to fill
the bath tub
CAUTION!
Check the water temperature by hand (without wearing gloves) or
with a thermometer to avoid scalding of the patient.
Image 3:
Turn the thermostatic valve
to set the temperature.
Image 4:
If the desired filling
height is reached,
close the tub filling
valve.
Image 5:
To use the hand shower,
you must open the hand
shower valve.
