Installation
2.2 Installation Process
A Thumb Screw Installation Tool (provided) or a slotted screwdriver is required
for installation.
1. Unpack and check the delivery. If damage is found, notify the supplier.
Note:
Place the operator panel on a stable surface during installation.
Dropping the operator panel or letting it fall may cause damage.
2. To cut a correct opening for the operator panel, use the cut out dimensions
in the outline drawing. A separate cut out drawing is available for download
from the Beijer Electronics web site. For more information, see sections
Operator Panel Drawings
and
Technical Data
.
3. Install the operator panel into the cutout with the terminal mounting ring on
the inside of the mounting panel with the connector bracket mounting holes
at the bottom and on the right side.
4. To secure the operator panel in position, insert the mounting blocks into the
openings on the side of operator panel, slide the blocks into position, and
tighten the thumbscrew. Tighten the screws (4) to 0.7 Nm ± 0.2 Nm.
Beijer Electronics, MAEN185
9
