GB
Sound module USM-RC-3
11.10.2021
BEIER-Electronic
99
Transferring configurations with data cable K-USB-2
If you often want to change sounds and configurations in the Sound-Teacher, it will
quickly become annoying inserting and pulling out the SD card between USM-RC-3
and card reader. To avoid time consuming reconnecting, it is possible to transfer
complete projects with the data cable K-USB-2.
In the menue „Data cable“ and „Upload project data
via data cable“ or with the button „Transfer project
data“ all sounds and settings are transferred onto the
SD card.
Transferring sounds with the data cable K-USB-2 takes a few minutes! A sound with
a length of 10 seconds takes about 15 - 45 seconds (depending on the transmission
speed) until it is transferred. Very long songs and large, new projects are only
restrictively recommended to be transferred with the data cable.
If a completely empty SD card is inserted in the sound module (e.g. reformatted), the
project cannot be written to the SD card with the data cable! An empty SD card must
always be written to once in the card reader on the PC using the Sound-Teacher.
During the transfer of the project data with the data cable, the connection to an IR or
BT light module in the trailer is disconnected!
Problems with the data cable
If problems occur, the transfer speed can be reduced in the menue „Data cable“.
USM-RC-3 can not be found with data cable
If the USM-RC-3 port can not be found with the data cable, check the port in the
device manager. If there is a yellow warning sign a new hardware driver (Prolific) is
required.
Windows:
With Windows 10 and later versions no additional hardware driver is required. For
older operating systems the hardware driver can be dowloaded on our website at the
product page data cable
Linux:
In combination with Linux, the data cable can also be used with the software
No extra hardware driver is required, however a COM port must be set using
following comand in your terminal window:
sudo chmod 777 /dev/ttyACM0
sudo ln -s /dev/ttyACM0 ~/.wine/dosdevices/com5
Mac OS:
The data cable is compatible with Mac OS in combination with the software
