BEIER-Electronic USM-RC-3, Operating Manual

Page: 60 / 123

GB Sound module USM-RC-3
60 BEIER-Electronic 11.10.2021
Kraftwerk EasyBus lighting boards
The USM-RC-3 can also directly control the EasyBus lighting boards from Kraftwerk.
This considerably simplifies the connection of the lighting. The signal for the
EasyBus lighting boards is available at connector X9 of the USM-RC-3. Attention:
Here an EasyBus adapter with matching connector (servo plug) is needed!
The 17 switching outputs of the USM-RC-3 can nevertheless be used for further
lighting.
The EasyBus lighting boards require at least the software version V4.08 to work with
the USM-RC-3. If the lighting boards have an older software version, they can be
updated via the Kraftwerk software " ControlPanel " and a KLM. Alternatively, the
lighting boards can also be sent to Kraftwerk for an update.
If Kraftwerk EasyBus lighting boards are to be connected to the USM-RC-3, this
must be activated in the Sound-Teacher (see page 66). Further settings are not
absolutely necessary for the lighting boards. Of course, the behavior of the lighting
can still be set under „Configuration“

„Outputs“

„Output options“.
With the Kraftwerk EasyBus lighting boards, there are, however, a few slight
restrictions that should be noted:
•
The lighting boards can not be controlled via output sequences
• The flickering of the lights during starting can not be set by the Sound-Teacher
(only via the Kraftwerk ControlPanel )
•
The light bulb effect can not be set by the Sound-Teacher (only via the
Kraftwerk ControlPanel )
•
The xenon effect can not be set by the Sound-Teacher (only via the Kraftwerk
ControlPanel )