Behringer X-USB Quick Start Manual Download Page 12

Page: 12 / 28

Warning

Failure to observe the following warnings may
lead to fatality or serious injury from fire or

electric shock.
Before installing the card, you must refer to the owner’s
manual of the host device or to behringer.com to verify that
your host device supports this card, and to verify the number
of cards that can be installed in combination with other
BEHRINGER or third-party cards.

•

Do not attempt to disassemble or modify the card.
Do not apply excessive force to board connectors or
other board components. Mishandling of board may
lead to shock, fire hazard, or equipment failure.

•

Disconnect the power cable from the main unit before
installing this card to eliminate shock hazard.

Caution

Failure to observe the following precautions may
lead to personal injury, or may result in damage

to equipment or other property.

•

Do not touch the board’s metallic leads (pins)
when handling the card. Pins are sharp and may
cause injury.

• The card is electrostatic-sensitive.

Before handling the card, you should briefly
touch the main unit’s metal casing with
your bare hand so as to drain off any static
charge from your body

. BEHRINGER assumes no

responsibility for data loss, equipment damage,
or injury caused by inappropriate handling or usage.

1. IMPORTANT NOTICE: DO NOT MODIFY

THIS UNIT!

This product, when installed as indicated

in the instructions contained in this manual, meets FCC

requirements. Modifications not expressly approved by

BEHRINGER may void your authority, granted by the FCC,

to use the product.

2. IMPORTANT

: When connecting this product to

accessories and/or another product, use only high quality
shielded cables. Cables supplied with this product MUST be
used. Follow all installation instructions. Failure to follow
instructions could void your FCC authorization to use this
product in the USA.

3. NOTE:

This product has been tested and found to

comply with the requirements listed in FCC Regulations,
Part 15 for Class “B” digital devices. Compliance with these
requirements provides a reasonable level of assurance that
your use of this product in a residential environment will not
result in harmful interference with other electronic devices.
This equipment generates/uses radio frequencies and, if not
installed and used according to the instructions found in
the users manual, may cause interference harmful to the
operation of other electronic devices. Compliance with FCC
regulations does not guarantee that interference will not
occur in all installations. If this product is found to be the
source of interference, which can be determined by turning
the unit “OFF” and “ON”, please try to eliminate the problem
by using one of the following measures: Relocate either this
product or the device that is being affected by the interference.
Utilize power outlets that are on different branch circuits
(circuit breaker or fuse) or install AC line filters. In the case of
radio or TV interference, relocate/reorient the antenna. If the
antenna uses 300 Ohm ribbon cable, use coaxial cable instead.
If these corrective measures do not produce satisfactory
results, please contact the local retailer authorized to distribute
this type of product. If you can not locate the appropriate
retailer, please contact BEHRINGER customer service.