ENGLISH
OPERATION
MANUAL
JB SYSTEMS
4/20
LC1 LASER CONTROLLER
11. OUTPUT XLR-CONNECTOR
: This output connector is used to connect one or
more laser units, by means of a good quality balanced signal cable with XLR-
♂
and XLR-
♀
connectors like for example JB Systems signal cable “7-0063”
12. MICRO:
The built-in microphone is used to synchronize the laser show to the
beat of the music.
13. MAINS INPUT:
The power-cord connects the laser controller to the 220V AC
mains.
INSTALLATION
•
Fix the laser units in a safe way and adjust to the suitable angle.
•
Connect the inputs/outputs of the units, using a balanced signal cable.
•
Connect the input of one unit to the Laser controller.
•
Set the MASTER / SLAVE switch on all units to “SLAVE”.
•
Connect the units to the 220V AC mains, using the supplied power cords.
•
Connect the Laser controller to the 220V AC mains.
•
Put the key switches of all units in ON-position.
•
The laser controller will act as master; it will control all the connected units.
SPECIFICATIONS
Power Supply:
AC 230 V, 50Hz
Power Consumption:
5W
Size:
175 x 115 x 55mm
Weight:
950g
Fuse:
250V ~ 100mA slow (
ø
5x20mm)