Beer Grill AG
Beer Grill GmbH
Allmendstrasse 7
Tel. +41 (0)56 618 7800
Körnerstrasse 14 a
Tel. +49 (0)71 61 659 876
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849
D
– 79539 Lörrach
Fax +49 (0)71 61 659 879
www.beergrill.com
Seite 3
1
Introduction
Carefully read these installation and operating instructions before installing the Culinario Fire
& Ice and putting it into service, and strictly follow the notices herein, this contributing to
keeping the device in a perfect and functioning state.
1.1 General safety instructions
•
Those covers bearing a warning may only be opened by specialists!
•
The bottom and back panels are not to be cleaned by water jet.
•
Protective covers and devices may not be removed due to risk of injury!
•
The control system may only be opened by an expert.
•
Air currents near the device resulting from improperly installed ventilation or draughts are
to be avoided, in order to ensure the efficient functioning of the refrigerating unit.
•
The surrounding temperature may not exceed 25 °C; the relative humidity may not ex-
ceed 60 % over a long period of time.
•
Due to risk of injury, sharp objects are not to be stored loosely in the Culinario Fire & Ice.
•
Any glass parts are to be treated with the necessary care in order to avoid injuries result-
ing from broken glass.
•
Components and operating equipment may only be replaced by original parts.
•
When using the cutting board, make sure that the two brackets (clampsc) that support
the surround of the cutting board are properly anchored to the frame of the device so that
the cutting board fixture can be properly hung.
ATTENTION:
Failure to do so may result in injury!
Fire hazard!
The Culinario Fire & Ice is wrapped in with plastic foil for protection. Remove this from
the warm-ing device. Also prior to commissioning, completely remove all external and
internal packaging material from the device.
The connection and any technical adaptations on the refrigerated well are only to be
carried out by specialists!
This is especially valid for any work on the cooling technology, electrical installation,
water connection and mechanical work. Any adaptation is to be authorized by the
manufacturer!
!
