Beem Leopard G5, User Manual

Page: 22 / 56

20
Leopard G5 EN
BEEM - Elements of Lifestyle
Appliance description
(See illustration on the left fold-out page)
Lid, pusher 1
Pusher 2
Tray 3
Release button 4
Handle 5
Motor unit 6
Switch A 7
Switch B 8
Fixture 9
feed shaft 10
Attachment 11
Drive pinion 12
Screw conveyer 13
Mincing knives 14
Perforated disc 15
15a Small perforated disc (Ø 3 mm)
15b Medium perforated disc (Ø 5 mm)
15c Large perforated disc (Ø 7 mm)
Locking ring 16
Pusher for shortbread biscuits 17
Shortbread biscuit attachment 18
Sausage filling disc 19
Kebbe attachment 20
Kebbe shaper 21
Sausage filling shaft 1 22
Sausage filling shaft 2 23
User manual (not illustrated) 24
Switch positions
Switch A (7) and switch B (8) at "ON" ■
position: normal operation
Switch A (7) at "0" position: appliance
■
switched off
Switch A (7) and switch B (8) at "R"
■
position: reverse operation
Overload protections
The motor is protected against overload-
ing by a thermal circuit breaker. It stops
automatically in the event of overloading.
In this case, switch off the appliance and
allow it to cool for approx. 60 minutes.
CAUTION
Observe the maximum operating ►
time of 10 minutes.
Allow the appliance to cool down
►
afterwards for 30 minutes before it is
switched on again.
Preparations
Preassembly
Using as mincer (image A)
Insert the screw conveyer (13) into the
‹
attachment (11).
Insert the mincing knife (14) with
‹
the blades facing outwards into the
square of the conveyer screw.
Put the desired perforated disc (15a,
‹
15b, 15c) onto the screw. The notch in
the perforated disc must lie over the
keyway of the attachment (image E).
Screw on the locking ring (16).
‹
Making sausages (image B)
Insert the screw conveyer (13) into the
‹
attachment (11).
Put the sausage filling disc (19) onto
‹
the screw. The notch in the sausage
filling disc must lie over the keyway of
the attachment.
Insert the desired sausage filling shaft
‹
(21, 22) through the locking ring (16).
Screw on the locking ring (16).
‹