Beem i-Joy Cafe, User Manual

Page: 35 / 104

BEEM - Elements of Lifestyle EN 31
Troubleshooting
The following table helps in localising and remedying minor faults. If you cannot resolve the
problem with the steps described, please contact customer service.
Fault Possible cause Remedy
Indicator lamps (12 - 14) do
not light up after switching
on.
Not plugged in. Insert the mains plug.
Fuse in electrical distribution
board defective/switched off.
Replace fuse or switch on
the circuit breaker.
The indicator lamp is defective. Contact customer service.
The fuse in the distributor
box triggers.
Too many appliances connec-
ted to the same power circuit.
Reduce the number of
appliances on the power
circuit.
No fault detected. Contact customer service.
Despite pumping noises,
no water comes out of the
appliance.
No water in the water tank. Fill with water.
Water tank incorrectly ins-
talled in the housing.
Install the water tank
properly.
Valve on the water tank is
clogged.
Clean the valve or allow to
be replaced by customer
service.
Briefly during initial use of a
new appliance.
The system of a new appli-
ance is empty. The noises
will decrease after the
appliance has been filled
with water.
Water runs out on the under-
side of the appliance.
Drip tray full. Empty the drip tray.
Valve on water tank leaking Contact customer service.
The espresso runs into the
cup very slowly.
Coffee powder pressed in too
firmly.
Press in the coffee powder
less firmly.
The coffee powder is ground
too finely.
Grind the coffee powder
less finely.
Espresso with ESE pad is
too watery.
ESE pad is not centred.
Centre the ESE pad in the
strainer insert.