Beem Cafe Joy V2, User Manual

Page: 38 / 120

36
Café Joy V2 EN
BEEM - Elements of Lifestyle
Preheating the appliance
Fill the water tank with water as de-
‹
scribed in the section Filling with
water (page 32)
.
Put the strainer insert into the holder
‹
as described in the section Installing
the strainer insert (S. 35) .
Insert the trainer holder (12) without
‹
coffee powder into the appliance as
described in the section Installing the
strainer holder (page 35)
.
Place a cup onto the drip tray (14) un-
‹
der the strainer holder (12).
Press
‹
/ (31). The green indicator
light "Espresso machine" (29) and
the yellow indicator light "Heater" (30)
light up and the appliance begins to
heat up.
After approx. 3 minutes, the yellow in-
dicator light "Heater" (30) extinguishes
Turn the function selection switch (5)
‹
to the position and allow the hot
water to run into the cup.
Turn the function selection switch (5)
‹
to the middle position when the cup
is full.
Making espresso
Preheat the appliance as described in
‹
the section Preheating the appliance
(page 36)
.
Check the water level in the water
‹
tank (1) and add water, if necessary.
Remove the strainer holder as de-
‹
scribed in the section Removing the
strainer holder (page 35) .
Fill the strainer insert (13) with coffee
‹
powder to the top and wipe off any ex-
cess coffee powder with the handle of
the measuring spoon (image C1, C2).
NOTE
Do not overfill the strainer insert. An ►
overfilled strainer insert cannot be
inserted into the appliance.
Press down the coffee powder lightly
‹
using the tamper (10) (image C3).
NOTE
Remove any surplus coffee powder ►
from the edge of the strainer holder
in order not to stain the seal of the
brewing unit (6).
Insert the strainer holder (12) into the
‹
appliance as described in the sec-
tion
Installing the strainer holder
(page 35) .
Place a cup onto the drip tray (14) un-
‹
der the strainer holder (12).