7
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Fitting the heat reflectors
Completely remove all of the plastic film from the reflectors�
The tabbed ends of the heat reflectors face forward to the
front of the barbecue frame� The tabs fit into the slots in the
front end of the barbecue (behind the control fascia)� Key
the tabs of the vaporisers into the lower slots (between the
burners)� Key the tabs of each reflector into the slots� If slots
are partially covered with enamel, work the tabs until the
enamel clears� See Fig 8�
Fitting the burners
Remove the retaining clips from the burners, then fit the
burners - open end first, over the brass stem of the control
valves at the front of the barbecue, allowing the rear
burner lug to locate into the cross-lighting channel and
corresponding hole in the support panel at the rear or the
barbecue� To secure burners fit retaining clips (“R” shape)
into burner lugs� See Fig 9 & 10�
FIG 8
FIG 9
Fitting the vaporisers
Remove the protective plastic film from each vaporiser and
then fit the vaporisers to the barbecue� The tabbed ends
of the vaporisers face forward to the front of the barbecue
frame� The tabs fit into the slots in the front end of the
barbecue (behind the control fascia)� Key the tabs of the
vaporisers into the upper slots� The vaporisers should be
fitted to the same side of the barbecue to which the grill is
to be placed� (They will not work if fitted under the plate)� If
slots are partially covered with enamel, work the tabs until
the enamel clears� See Fig 11 & 12�
FIG 10
FIG 11
Summary of Contents for signature plus
Page 34: ...34 NOTES NOTES ...
