Weedbrush-Edgecutter
Type: BECX OBKS90-45
Version: 2
November 2019
Page 19 of 27
5
Maintenance
•
Only components supplied or approved by the manufacturer must be used for
replacement or repair of parts.
•
Always disconnect the weed brush from the feed line when work is carried out
on the machinery. This is done by disconnecting the rapid attachment.
•
Only persons who can show that they have adequate knowledge of
mechanical and hydraulic machinery through their training and experience are
allowed to carry out maintenance work.
•
The installation can be cleansed with a high pressure cleanser, never point
directly at hydraulic components.
Weekly maintenance
No.
What to do
Action
Result
1
Grease the pivot
points
•
Squeeze grease into the grease nipples.
These are located at all pivot points
2
Tightening bolts
•
Check and tighten all bolts
3
Visual check
•
Visually check the construction, the
hydraulic aggregate and the cutter blades
for damage and cracks.
•
Check cylinder-rods for damages and dirt.
4
Retighten adjusting
bolts
•
Whitin 4 working hours, tighten the set
screws of the clamping sleeve mounting on
the motor shaft and then check it regularly!
( 48NM) See image on page 20.
