User Manual | EMS-8x / EMS-8x-TE | Beckmann GmbH
The clamps are equipped with CAGE CLAMP ® connection technology for slotted screwdriver
operation only.
The following sequence must be followed during the electrical installation (see Figure 3):
1. Insert a flat-head screwdriver (3x100) in the square clamp opening and possibly
exert a slight pressure on the spring. Do not turn the screwdriver!
2. Insert the stripped wire through the round clamp opening into the opened spring
cage.
3. Remove the screwdriver.
4. Check the fixed position of the conductor by gently pulling the cable!
CAUTION:
Do not push the wire into the square clamp opening!
Do not push the wire into the clamp before clamp is fully opened ! (refer to
sequence above)
Otherwise, the contact is not sufficient and it may create sparks or fires!
Defects by a non-professional installation are not covered by the guarantee or
warranty - Liability for consequential damages are excluded!
Figure 4:
Handling instructions for wire connection
Page 8
